Quick Specs
The Generic mounting interface encompasses all other mounting interfaces outside of the ones listed above. Unless indicated to be tool-less, tools are required for installation.
Stab-in Sliding rails require the inner (chassis) rail members must first be attached to the sides of the system and then inserted into the outer (cabinet) members installed in the rack and allow a system to be portion extended out of the rack for service. For systems that are 2U and larger, it is recommended that two people perform this operation. Most stab-in Sliding rails are compatible with CMA and SRB solutions.
Cable management arm (CMA) is a cable management accessory which connects to the rails behind the system. It allows a fully cabled system to be extended out of the rack into a service position.
Strain relief bar (SRB) is a cable management solution, which in most cases, attaches to the back of the rails via the strain relief bar brackets. Cables from the back of the chassis are placed across the top of the SRB and secured by straps.
Round-hole describes a 4-post rack mounting flange type where rails utilize Unthreaded-Round holes sized according to EIA-310- D standard for mounting.
| Rail identifier | Mounting interface | Rail type | Rack types supported | Rail adjustability range (mm) | Rail depth (mm) | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 4-Post | 2-Post | Square | Round | Threaded | without CMA/SRB | with CMA(SRB) | |||||||||
| Square | Round | Thread | Flush | Center | Min | Max | Min | Max | Min | Max | |||||
| A27 | Generic Tool-less | Stab-in Sliding h,t | - | X | - | - | - | - |
- |
432 |
562 | - | - | - | - |
| s Rail is only intended for use with ruggedized transit case (Pelican custom rack 25-036329-01) | |||||||||||||||
- Dell XR5610
(Click to View)