Previous | Next
Home / All / R1-2210 - Dell PowerEdge VRTX 10GbE I/O Module Switch (4x SFP+ External / 16x Internal / 2x 1GbE)

Refurbished
R1-2210 - Dell PowerEdge VRTX 10GbE I/O Module Switch (4x SFP+ External / 16x Internal / 2x 1GbE)

Dell

| Module
Contact For Pricing

Thanks for the request. We'll get back to you with in 24 hours.

Condition: Refurbished ✓ Pulled from working servers & Tested. ✓ 1-year Parts Warranty.

Warranty | Return Policy

Quick Specs
  • Dell VRTX R1-2210 10GbE I/O Module Switch: 4x 10GbE SFP+ external, 16x 10GbE internal and 2x 1GbE ports.
  • This switch is for the VRTX so the nodes / sleds / blades can be accessed.
  • layer 2
  • Internal 10Gb SFP+ ports: 16
  • External 10Gb SFP+ ports: 4
  • External 1Gb RJ45 ports: 2
  • Total ports: 20x 10GbE (16 internal + 4 external) plus 2x 1GbE
  • Server connections: 4 internal 10GbE lanes per server module, 16 total (Fabric A)
  • Management port: 1 out-of-band port (shared with the chassis CMC)
  • Console: external UART console port
  • Switching mode: Layer 2+ with IPv4 static routing (always enabled on the R1-2210)
  • IPv6: dual-stack IPv4/IPv6 host support
  • MAC address table: up to 16K entries
  • Link aggregation: up to 32 LAGs with up to 8 member ports each, LACP
  • VLANs: IEEE 802.1Q tagging, port-based VLANs, GVRP and Voice VLAN
  • Spanning tree: STP (802.1D), RSTP (802.1w) and MSTP (802.1s)
  • Multicast: IGMP snooping and MLD snooping
  • QoS: 802.1p class of service and ACL-based advanced QoS
  • Jumbo frames: up to 10 Kb
  • Management: web GUI, CLI over Telnet or SSH v2, SNMP v1/v2/v3, RMON and sFlow v5
  • Security: RADIUS, TACACS+, 802.1x authentication and ACLs
  • Chassis: Dell PowerEdge VRTX, Fabric A I/O module bay
  • Minimum CMC firmware: VRTX CMC 2.00
  • Regulatory model: E12M
  • Included: Dell PowerEdge VRTX R1-2210 10GbE I/O module switch with SFP+ transceivers (no cables)
Part Number:
  • R1-2210

The VTRX 10GbE Switch Module, model R1-2210, is a layer 2 switch that supports speeds up to 10 Gbps. Both the switch GUI and CLI provide access for configuring the switch. The OOB management IP must be on a different IP subnet than those defined on all other switch interfaces (port, VLAN). Blade servers are connected to internal (te 1/1 – te 4/4) ports. The internal ports communicate together allowing for east-west traffic. The external ports allow for north-south communication to any upstream devices on the network as if the ports were typical switching/bridging device.

Compatible With:

(Click to View)